High-voltage test pistols

Safe testing with high-voltage.

At manual high-voltage tests the test object is contacted with high-voltage test pistols.

Different HV-test pistols for different test tasks are available.

Safety HV-test pistols allow a safe, manual contacting at single test points.

The test tip is made of almost wear-free lungsten and assures a long lifetime.  Furthermore the test tip is protected by an arc-resistant teflon tube.

The start button in the handle is protected against accidental activation.

High-voltage test with safety test pistols.

Our safety test pistols are available either with or without integrated start button.
The picture shows test pistols without start button. Thus, either the start button at the tester´s front or the foot switch has to be activated to start the test.

Impressions

60204-test at a cabinet

• One-hand operation with release by an operating panel
• Test between pistols and ground
• Inspection of
  
  • PE-resistance with10 A
  • Insulation resistance
  • High-voltage AC or DC

High-voltage test

• Two test pistols

High-voltage test via adapter

• Adapter to connect the test object´s plug
• Contact pads on the adapter where the test pistols are to be pressed on 

High-voltage tests at motors

• Fault-to-frame test between winding and motor housing

High-voltage tester integrated in a mobile caddy 

• Perfect for mobile use
• Integrated compartment on the right side of the tester

Technology at a glance.

High-voltage test probe for testers with 3mA safety current limiting 

• Lead length 2 m
• Test voltage AC 1,5 KV
• Test voltage DC 2 KV

High-voltage test pistols with trigger in the handle to extend the test tip

• Lead length 2, 4, 6, 8, 10 m
• Test voltage AC 8 KV
• Test voltage DC 10 KV
• High-voltage is not led through handle
• Test tip diameter only 1,6 mm

High-voltage test pistols with trigger and button in the handle to extend the test tip

• Lead length 2, 4, 6, 10 m
• Test voltage AC 8 KV
• Test voltage DC 10 KV  

High-voltage test pistols with trigger to extend the test tip and integrated push button

The test is started by pressing the extended test tip against the test object.
By this, an internal switch is activated in the test pistols . The test is started, as soon as both switches are activated in the pistols .

• Lead length 2, 4, 6 m
• Test voltage AC 8 KV
• Test voltage DC 10 KV

High-voltage test probe with trigger to extend the test tip

• Lead length 2, 6, 10 m
• Test voltage AC 12 KV
• Test voltage DC 15 KV

High-voltage cable with connection plug 

• Lead length 2, 4, 6, 8, 10 m
• Test voltage AC 8 KV
• Test voltage DC 10 KV

High-voltage cable with connection plug and alligator clamp

• Lead length 2, 4, 6 m
• Test voltage AC 8 KV
• Test voltage DC 10 KV